- 10,000+ Products
- Australian Stock & Warranty
- We accept Purchase orders
D-LINK DPS-800 – 2-Bay Redundant PWR Supply Chassis
$362.95(inc. of GST)
Buy now, pay smarter. Learn more
The DPS-800 is designed to conform to the wattage requirements of D-Link’s Ethernet and Gigabit switches. DPS-800 2-slot chassis: accommodates 2 DPS-200/300/500/500DC in a 19-inch equipment rack
Redundant Power Supplies
The DPS-800 is designed to conform to the wattage requirements of D-Link’s Ethernet and Gigabit switches. They are external RPS units enclosed in solid metal cases with sockets to AC or DC power sources on one end, and connect to a switch’s internal power supply on the other end.
They provide a low-cost, simple solution to the problem of an inadvertent failure of the internal power-supply of an Ethernet switch, which can result in the shutdown of that switch, the devices attached to its ports, or an entire network. Supporting full output power for the switch, these redundant power supplies can maximize the power availability of the switching device
Redundant Power Backup
Each D-Link RPS is equipped with an integrated detection circuit that continuously monitors the switch’s internal power supply. In the event of a power interruption, the redundant power supply is immediately triggered so that the LAN switch and its connected devices can continue providing service.
This results in a more reliable network infrastructure and protects the network from going down due to failure of a single network device power supply.
The DPS-800 chassis can accommodate up to two DPS-200, DPS-300 or DPS-500/500DC modules to an equipment rack
What’s in it for you??
- Connect to D-Link Ethernet and Gigabit switches
- Provide backup power for switch’s built-in power supply
- Can be installed as stand-alone power supply units or mounted in a 19-inch multi-slot chassis
- Hot swappable when installed in a chassis
- Solid metal case housing
- LED status indicators
- Over-current protection
- DPS-800 2-slot chassis: accommodates 2 DPS-200/300/500/500DC in a 19-inch equipment rack
|482 x 180 x 55 mm|